Static Pppoe - D-Link DIR-615 User Manual

Section 3 - Configuration
Click Static PPPoE radio button if your ISP uses a static PPPoE connection. Your ISP will provide you with a username
and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
Dual LAN
Tick the check box to enable IP Unnumbered on LAN (1-3)
Enable:
interface and NAT on Wireless Interface.
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password.
Confirm
Password:
Retype the new password.
Service Name:
Enter the ISP Service Name (optional).
IP Unnumbered
Address:
Enter the IP address (Static PPPoE only).
IP Unnumbered
Netmask:
Enter the IP netmask (Static PPPoE only).
LAN IP:
Enter Start and End LAN IP address.
DNS: Click Recieve DNS from ISP to get the DNS automatically.
Click Enter DNS Manually to enter the DNS information
below.
DNS
Addresses:
Enter the Primary and Secondary DNS Server Addresses.
D-Link DIR-615 User Manual
Internet Setup

Static PPPoE

18