Status Display Screens - Lochinvar EcoKnight EKW45CE User & Smart System Control Manual

2.4

STATUS DISPLAY SCREENS

Status Display Screens
By using the Previous/Next (◄, ►) arrow keys on the SMART SYSTEM display panel, you can navigate through the six (6)
display screens. Each screen will contain two (2) viewable items. The following is a description of the individual items and
what they can display:
Screen Display shows:
WHR: OFF
STANDBY
SET POINT MET
PREPURGE
IGNITION
1 RUN***% RATE
POSTPURGE
SERVICE
OUT:***.*C
OPEN
SHORTED
Press the Next ► arrow key on the SMART SYSTEM display to access Screen 2
IN: ***.*C
***.*C (***)
2 OPEN
SHORTED
RISE: ***.*C
Press the Next ► arrow key on the SMART SYSTEM display to access Screen 3.
FLUE: ***.*C
OPEN
SHORTED
3
TANK: ***.*C (***)
OPEN
SHORTED
Press the Next ► arrow key on the SMART SYSTEM display to access Screen 4.
FAN SPD: ****RPM
4
FLAME SIG: **.*UA
Description
The unit has been turned OFF by the Enter/Reset button on the SMART
SYSTEM display panel.
The unit has not received a call for heat from a tank thermostat nor has
it received a call for heat from a tank sensor.
The unit has met the water temperature set point, but is still receiving a
call for heat from either a tank sensor or a tank thermostat.
The unit has initiated a 10 second purge period on a call for heat.
The unit has begun a 5 second spark period to ignite the main burner.
The unit has fired and is running at the displayed percentage.
The call for heat has been satisfied and the unit runs the fan for an
additional 10 seconds to clear the combustion chamber and vent system
of residual flue products.
The unit has been placed in a temporary mode that will allow the unit to
fire at 100% of rate for the purpose of combustion analysis.
The outlet temperature is displayed.
The control does not detect the outlet sensor.
The outlet sensor wires or the sensor itself has become shorted.
If a tank sensor is installed, only the inlet temperature will be displayed.
When a tank thermostat is installed, the control will display the inlet
temperature as well as the set point in brackets.
The control does not detect the inlet sensor
The inlet sensor wires or the sensor itself has become shorted.
The difference between the inlet temperature and the outlet
temperature.
The control will display the flue temperature.
The control does not detect the flue sensor.
The flue sensor wires or the sensor itself has become grounded.
The control will display the tank temperature; if used, the set point
appears in brackets.
The control does not detect the tank sensor.
The tank sensor wires or the sensor itself has become shorted.
The control will display the actual fan motor RPM.
The control will display the flame signal in dc micro amps.
7