Starting Up/Shutting Down - Panasonic CF-27 Series Operating Instructions Manual

Starting Up/Shutting Down

Starting Up
4
2
Latch
Power Switch
1
Open the display
Pull the carrying handle forward.
1
Slide the latch toward the rear of the computer and hold it with one finger.
2
1
3
Lift up the latch with another finger.
3
4 Lift open the display.
2
Turn your computer on
Slide the power switch toward the rear of the computer and hold it for approximately
one second until the power indicator turns on before releasing it.
CAUTION
The computer will not power on when the display is closed (except when con-
necting an external display).
After confirming that the power indicator has turned on, avoid the following
until Windows has completed loading.
• Touching the power switch.
• Performing any keyboard, touch pad, touchscreen (or external mouse) opera-
tions.
• Closing the display.
If the display is closed while Windows is starting up, it is possible that color, etc.,
will not be displayed properly. Run the [MS-DOS Prompt] ([Start] - [Programs]
- [MS-DOS Prompt]), and use full screen display mode by pressing Alt +
Enter .
After returning from the full screen mode Alt +
will be shown correctly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
When the CPU temperature rises, the computer may not power on to prevent the
CPU from overheating. Should this happen, allow the computer to cool down
then switch the power on again.
If the computer still does not power on, please contact Panasonic Technical
Support.
If security indicator (
you must first enter your password. (
Upon entering your
password and press-
ing Enter .
When an application or file that was previously displayed ap-
pears on your screen,
the suspend or hibernation function has been set. (
Functions")
) is displayed,
If the correct password is input,
Over three incorrect attempts,
or no password is entered for about a minute,
*
If you are starting from the suspend or hibernation mode (
"Suspend/Hibernation Functions"), if after three attempts the correct pass-
word is not input, or if no password is entered for about a minute, the
computer returns to the suspend or hibernation mode.
Enter again, the display
"Security Measures")
Will Start
Will Not Start*
(Power off)
"Suspend/Hibernation
11