Riding Tips; Addendum To Instructions - Honda Goldwing GL1200 Installation Manual

14.

RIDING TIPS

The cruise control engages most smoothly when the engine is under load. We recommend SETTING or
RESUMING cruise operation while holding a constant speed. Maintain speed using the throttle: a) for a couple
of seconds after pressing the SET key to allow time for the cruise control to take up cable free play; and b) until
you feel the cruise take over after pressing RESUME.

ADDENDUM TO INSTRUCTIONS

Mounting the computer on bikes equipped with seat adjustment release lever.
• The computer can be attached to the side of the fuel spill tray as
shown in the photos using double sided self adhesive foam tape
or similar material.
Mounting the ECS on bikes equipped with seat adjustment release lever.
• Mount the switch on the fuel tank as shown. Clean the tank
with methylated spirits (wood alcohol) and mount the switch
with small self adhesive pads supplied in the kit.
• Route the orange and purple wire to the cruise control
computer and connect the two pin plug to the matching plug on
the short wires coming out of the computer plug.
• The green earth wire with the eye connector should be attached
under the head of the bolt that attaches the front seat mount.
• Return to P19 of the instructions.
Honda Goldwing GL1200 ©
• Connect the loom plug to the computer as shown.
• Return to P17 of the instructions for loom routing.
28