Table of Contents
Advertisement
Bearing Housing and Connecting Rod
WARNING
INJECTION HAZARD
To reduce the risk of serious injury,
whenever you are instructed to relieve
pressure, follow the Pressure Relief
Procedure on page 7.
NOTE: Read General Repair Information on page 16
before doing this procedure. See Fig. 17.
NOTE: Stop sprayer at bottom of its stroke to get crank
(E) in its lowest position.To lower crank manu-
ally, carefully rotate blades of fan with a screw-
driver.
1. Relieve pressure.
2. Remove front cover (49). Unclip drain hose (36)
from pump. Hold a wrench on pump intake valve
(213) and unscrew pump suction tube (39). Dis-
connect pump hose (70).
3. Push up retaining spring (68). Push pin (66) out
rear.
4. Loosen locknut (47). Unscrew displacement
pump (64).
5. Remove four screws and lockwashers (25,23).
6. Lightly tap lower rear of bearing housing (22) with
a plastic mallet to loosen it from drive housing (67).
Pull bearing housing and connecting rod assembly
(63) straight off drive housing.
7. Remove pail bracket assembly (F) and install it on
new bearing housing.
8. Inspect crank (E) for excessive wear and replace
parts as needed. Evenly lubricate inside of bronze
bearing (B) with high quality motor oil. Liberally
pack roller bearing (C) with bearing grease.
9. Assemble connecting rod (63) and bearing housing
(22).
10. Clean mating surfaces of bearing and drive hous-
ings (22,67).
24
308800
Replacement
11. Align connecting rod (63) with crank (E) and drive
housing locating pins (G) with bearing housing (22)
holes. Push bearing housing onto drive housing or
tap it into place with a plastic mallet.
DO NOT use the bearing housing screws (25) to try
to align or seat the bearing housing; the bearing and
drive housing will not align properly and will result in
premature bearing wear.
12. Install screws and lockwashers (25,23). Tighten
screws evenly to 175 in-lb (19 N.m).
13. Install pump. See page 30.
14. Install remaining parts. See Fig. 17.
67
E
Fig. 17
CAUTION
B
OIL
G
22
68
47
70
40
64
213
39
85
PACK WITH
C
BEARING GREASE
63
TORQUE TO
25,23
175 in-lb (19 N.m)
49
66
F
36
7698A
Advertisement
Table of Contents
