Clarke EZ Sand-HDTR Operator's Manual page 8

MACHINE SET-UP
This sanding machine is designed to be operated with a remote
vacuum dust collection system or with the included dust bag.
Preparing Remote Vacuum Dust Collection Systems
To prepare the machine for remote vacuum dust collection systems that
have a 2" hose end, install 2" hose end (fi gure 5, A) directly over the
exhaust tube (fi gure 5, B).
To prepare the machine for remote vacuum dust collection systems that
have a 1 ½" hose end, follow this procedure:
1. Install the 2" x 1½" hose end adaptor (Part No. 30563A) (fi gure 5,
C) over the exhaust tube (fi gure 5, B).
2. Insert 1 ½" hose end (fi gure 5, D) into the adaptor (fi gure 5, C).
NOTE: Start the remote vacuum collection system before
operation.
Preparing to use the included dust bag
To prepare the machine for use with the included dust bag (Part No.
53673A), follow this procedure:
1. Install the dust bag by pressing the end onto the exhaust tube
until the ring locks into the groove (fi gure 6).
2. To remove the dust bag from the exhaust tube, pry up the end
of the bag opening to partially release the internal rib from the
groove, then pull.
3. To empty the dust bag, unzip the disposal fl ap and force contents
out by inverting the bag.
NOTE: For best results, empty frequently. Follow all warnings
posted in this manual and on the dust bag.
®
American Sanders Operator's Manual (EN) - EZ Sand - HDTR
Clarke
ENGLISH
1.5" Hose from
vacuum system
(not included)
D
A
2" Hose from
vacuum system
(not included)
B
Exhaust Tube
Figure 5
Figure 6
EN
(30563A)
2" Tube x
1.5" hose
adaptor
(not in-
cluded)
C
Install the dust
bag by pressing
the end onto the
exhaust tube
until the ring
locks into the
groove.
- 7 -