Rear - Sony XCL-U100 Technical Manual

Rear

e DC IN (DC power input) connector (12-pin)
5
e DC IN (DC power input) connector (12-pin)
You can connect a camera cable CCXC-12P05N etc. to
input the +12 V DC power supply. The pin configuration
of this connector is as follows. You can operate the
camera without using this connector when using a
PoCL-compatible camera module interface board.
For details on the pin arrangement, see the following
table.
Pin No. Signal
1 Ground
2 +12 V DC
3 Ground
4 NC
5 Ground
6 NC
* Signal output from the Tenth pin of 12 pins
connector
You can select one of the following signals according
to the setting.
Ground / DVAL output / Exposure pules output
The default setting in the factory is Ground.
f DIGITAL IF (Interface) connector (26-pin mini
conector)
Camera Link Base Configuration:
You can connect a Camera Link cable to this connector
to control a camera module from a host device utilizing
the serial communication protocol while outputting a
video signal from the camera module. If you use a
camera module interface board with support for PoCL,
you can also supply power from this connecter. You can
input the external trigger signal via the 26-pin mini
connector and operate a camera module in the external
trigger mode.
The following table shows the relation between the pin
numbers of the DIGITAL IF connector and the input/
output signals and the like.
8
Location and Function of Parts and Operation
f DIGITAL IF (Interface) connector (26-pin mini connector)
6
Pin No. Signal
7 NC
8 Ground
9 NC
*
10 Signal output
11 Triger pulse input
12 Ground
Pin No. Signal
1 Power supply or
*
Ground
2 X0– output
(Signal)
3 X1– output
(Signal)
4 X2– output
(Signal)
5 XCLK– output
(Signal)
6 X3– output
(Signal)
7 SerTC+ (Signal)
8 SerTFG– (Signal)
9 TRIG– input
(Signal)
10 NC
11 NC
12 NC
13 INNER_SHIELD
(Ground)
* About the 1st pin and 26th pin of the 26-pin mini
connector
The connection differs depending on the type of
camera module interface board you use.
In the case of PoCL support:
Both the 1st pin and 26th pin are
POWER (power supply)
In the case of non-PoCL support:
Both the 1st pin and 26th pin are
INNER_SHIELD (Ground)
Pin No. Signal
14 INNER_SHIELD
(Ground)
15 X0+ output (Signal)
16 X1+ output (Signal)
17 X2+ output (Signal)
18 XCLK+ output
(Signal)
19 X3+ output (Signal)
20 SerTC– (Signal)
21 SerTFG+ (Signal)
22 TRIG+ input
(Signal)
23 NC
24 NC
25 NC
26 Power supply or
*
Ground