Calibration - Mitsubishi Electric FR-V5AX Instruction Manual

3.4 Calibration

(1) When Pr. 406 = 0 or 5 (speed setting), calibration is made as shown below.
* When Pr. 406 = 5 (speed limit setting for torque control), the input from the No. 6 terminal is valid for
the driving mode only. It is invalid for the regenerative mode.
(2) When Pr. 406 = 2, 3 or 4 (torque command), calibration is made as shown below.
* When Pr. 406 = 2 (torque limit), the input from the No. 6 terminal is valid for the regenerative mode only.
Speed
Factory setting
(1500r/min)
-10V
0
Pr. 926
Output torque
(150%)
-10V 0
Pr. 928
(150%)
8
HIGH RESOLUTION ANALOG INPUT
Pr. 927
Input voltage
10V
Pr. 929
Input voltage
10V