Burner Flame - Amana GUI* Installation Instructions Manual

6. Replace burners and burner retention bracket, inspect
the burner assembly for proper seating of burners in
retention slots.
7. Reinstall the burner box front cover.
8. Turn on electric power and gas supply to the furnace.
9. Check furnace for proper operation.
Check the burner flames for:
1. Good adjustment
2. Stable, soft and blue
3. Not curling, floating, or lifting off.
Figure 41

Burner Flame

GENERAL INFORMATION
1. When ordering any of the listed functional parts, be
sure to provide the furnace model, manufacturing, and
serial numbers with the order.
2. Although only functional parts are shown in the parts
list, all sheet metal parts, doors, etc. may be ordered by
description.
3. Parts are available from your Amana distributor
Gas Valve
Gas Orifice, Natural
Gas Orifice, Propane
Burner
Igniter
Flame Sensor
Gas Manifold
Ignition Control
Limit Switch
Pressure Switch
Pressure Switch Hose
Induced Draft Blower
Collector Box
31
Blower/Box Gasket
Flame Rollout Switch
Auxiliary Limit
Heat Exchanger
Door Switch
Transformer
Blower Wheel
Blower Housing
Blower Cutoff
Blower Motor
Motor Mount Bracket
Capacitor