Table of Contents
Advertisement
To create the new area setting press the 'New' function key and the edit screen shown in Figure 53 will be
displayed.
Figure 53 Regional area editing screen
1. The scroll wheel can now be used to scroll to the field to edit.
2. Select the field by pushing the scroll wheel or pressing the 'Edit' function key.
3. Enter a value, or select from a list of possible values using the scroll wheel.
4. Press the 'OK' or 'Cancel' function key to confirm or cancel the entry.
5. Repeat the process 1 - 4 for each field to be edited.
6. Press the 'Back/Save' function key to save the regional area setting and return to the area settings list
7. You will be prompted to confirm storage of the regional area setting with the display shown in Figure 54.
8. After confirmation of the regional settings the settings are stored and may take effect immediately de-
pending on the location of the vessel.
Figure 54 Regional area settings confirmation screen
4.8.2
Editing an existing regional area setting
To edit an existing regional area setting press the 'Menu' key and select the 'Installation' and then the 'Regional
areas' sub-menu. The display now shows a list of the current regional area settings as shown in Figure 52. Use
the scroll wheel to scroll to and select the regional area setting entry to be edited, then follow the instructions
for creating a new regional area setting in section 4.8.1.
13:20:47
OK
EDIT REGIONAL AREA:
In Use:
No
Time of In Use:
--:--:--
Info Source:
Not Available
Channel A:
2087
Channel B:
2088
Channel A BW:
Default
Back
13:20:47
OK
SAVE REGIONAL AREA:
Are you sure you want to save the
edited Regional Area?
Area settings may take effec t
immediately!
No
INT
GPS
INT
GPS
Yes
Installation
Page 51
Advertisement
Table of Contents
