Scanning Sequence Examples; Errors While Scanning; Imaging Preferences Parameter Defaults - Symbol DS6707 Product Reference Manual

5 - 2 Symbol DS6707 Digital Imager Scanner Product Reference Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to disable the decode aiming pattern,
scan the Disable Decode Aiming Pattern bar code listed under
imager scanner issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

Imaging Preferences Parameter Defaults

Table 5-1 lists the defaults for imaging preferences parameters. There are two ways to change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Download data through the device's serial port using SSI. Hexadecimal parameter numbers are shown in this
chapter below the parameter title, and options are shown in parenthesis beneath the accompanying bar
codes. See the Simple Serial Interface (SSI) Programmer's Guide for detailed instructions for changing
parameters using this method.
NOTE See
miscellaneous default parameters.
Imaging Preferences Parameter Defaults
Table 5-1
Parameter
Imaging Preferences
Operational Modes
Image Capture Autoexposure
Image Capture Illumination
Illumination Bank Control
Fixed Exposure
Fixed Gain
Gain / Exposure Priority for Snapshot Mode
Snapshot Mode Timeout
Snapshot Aiming Pattern
Image Cropping
Appendix A, Standard Default Parameters
Decode Aiming Pattern on page
Set Default Parameter on page
for all user preferences, hosts, symbologies, and
Parameter
Number
N/A N/A
F0h 68h Enable
F0h 69h Enable
F1h 3Bh Full
F4h F1h 37h 100
F1h 38h 50
F1h 32h Autodetect
F0h 43h 0 (30 seconds)
F0h 2Ch Enable
F0h 2Dh Disable
4-12. The digital
4-4.
Page
Default
Number
5-4
5-5
5-6
5-7
5-8
5-8
5-9
5-10
5-10
5-11