Using Comfort Functions/Switching On and Off
Using the Remote Programming Option
3 4 6 7
5
2
8
9
1
0
10
3 4
5 6
7
2
8
1
9
10
2
1
3
0
0
4
Initial Start-up and Re-starting the Heating System
1 2 3
0
0
4
3 4 6 7 8
5
2 1
9 10
0
3 456 7 8
2 1
9 10
16
The programming unit provides you with the option of programming your right from
your armchair. Simply remove the programming unit from the control base in the
front of the boiler or, if used as remote control, from the wall-mount base, and
perform your programming from wherever convenient.
Be sure to insert the programming unit in the control unit or wall-mount base upon
completion of your programming.
The following options can be
programmed:
H Time programs
H Room temperature values
H Heating curves
H Time and date
Initial start-up and adjustment of the control unit to local conditions and the
structural characteristics of your building must be performed by your heating
contractor.
We recommend that you contact your heating contractor before re-starting the
heating system if it has been shut down for a long period of time.
To start up the system
1. Check heating system pressure on
the pressure gage 1.
Minimum system pressure 12 psig.
If the needle of the pressure gage is
below 12 psig, the system pressure
is too low, in which case you must
contact your heating contractor.
2. Open the gas shutoff valve 2 (field
supplied).
3. Switch on line voltage (e.g. at
separate fuse/circuit breaker).
4. Switch on the heating system on/off
switch 3.
Your heating system is now ready for
operation.
Before using the "remote programming
option" for the first time, insert the
programming unit in the control unit or
in the wall-mount base for approx. 2
minutes. Switch off the heating
system switch on the control unit
before removing and inserting the
programming unit.