Set Time; Listen To Fm Radio; Tune To Fm Radio Stations; Store Fm Radio Stations In Memory - Philips AJT3300 User Manual

• In Aux mode, if the audio-in cable is
disconnected or music playback is stopped
for 15 minutes, this product switches to
standby mode automatically.

Set time

Note
•
You can only set time in standby mode.
1
Press and hold SET TIME for two seconds
to activate clock setting mode.
» The hour and minute digits blink.
2
Press HR repeatedly to set hour.
3
Press MIN repeatedly to set minute.
4
Press SET TIME again to confirm.
» The set time is displayed.
Note
•
The clock radio exits time setting mode when being
idle for 10 seconds.
6 EN
4 Listen to FM
radio
Note
•
Keep the clock radio away from other electronic
devices to avoid radio interference.
•
For better reception, fully extend and adjust the
position of the FM antenna.

Tune to FM radio stations

1
Press SOURCE repeatedly to switch to FM
tuner mode.
2
Press and hold TUNE - or TUNE + for 2
seconds.
» The clock radio tunes to a station with
strong reception automatically.
3
Repeat step 2 to tune to more radio
stations.
To tune to a station manually:
In tuner mode, press TUNE - or TUNE +
repeatedly to select a frequency.
Store FM radio stations in
memory
You can store up to 10 FM radio stations.
1
Tune to an FM radio station.
2
Press and hold PRESET for two seconds.
» The preset number begins to blink.
3
Press TUNE - or TUNE + to select a
number.
4
Press PRESET again to confirm.
5
Repeat steps 1 to 4 to store other stations.
Tip
•
To remove a pre-stored station, store another station
in its place.