Procedure 2.2 - Displaying The Odometer (917Si Only) - Precor 9.17 Appendix

Procedure 2.2 - Displaying the Odometer
The keys on the display are hypothetically numbered for 1 to 7 from left to right. Therefore,
INCLINE would be key 1, INCLINE
This procedure allows you to display the number of miles or kilometers logged on the treadmill.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker
Press keys RESET,6,5, sequentially.
2.
3. The console displays the number of miles or kilometers logged on the treadmill. Press the
STOP key to continue.
4. The total number of hours the treadmill drive motor has been operating will be displayed.
Press the STOP key to continue.
The software version will be displayed. Press the STOP key to continue.
5.
6. The error code log will be displayed. There may be up to ten error codes logged. The error
code and the odometer reading when the error occurred will be displayed. Use either
move forward through the error code log position. Use either
error code log.
7. If you no longer require the contents of the error code log for troubleshooting and wish to
clear the error code log, press the STOP and QUICK START keys, simultaneously.
Press the STOP to exit.
8.
(917si only)
would be key 2, etc.
917, 917si Treadmillr
to backward through the
to
Page 6