Phases Of The Diagnostic Cycle - Electrolux EWM2100 Service Manual

Hide thumbs Also See for EWM2100:
Table of Contents

Advertisement

4.3 PHASES OF THE DIAGNOSTIC CYCLE

Irrespective of the type of PCB and the configuration of the programme selector it is possible, after entering
diagnostic mode, turning the programme selector clockwise or pushing the buttons P1 or P2 (INPUT
version), to perform diagnostics on the operation of the various components and to read the alarms.
All the alarms are enabled during the diagnostic cycle.
Selector position
- All the LEDs and symbols light
in sequence.
- When a button is pressed, the
1
corresponding LED or symbol
light.
-
Door interlock
2
- Wash solenoid
- Door interlock
3
- Pre-wash solenoid
- Door interlock
4
- Pre-wash and wash solenoids
- Door interlock
5
- Bleach/stains solenoids
-
Door interlock
- Wash solenoid if the level of
water in the tub does not
6
cover the heater
- Heating element
- Recirculation pump
- Door interlock
- Wash solenoid if the level of
7
- Motor (55 rpm clockwise, 55
- Door interlock
- Drain pump
8
- Motor up to 650 rpm then at
- Door interlock
- Drain pump
- Motor fan
9
- Condensation solenoid valve
- Drying heating element
03-2009 SOI/DT-mdm FCPD-dp Quality-fz
Components actioned
water in the tub does not
cover the heater
rpm counter-clockwise, 250
rpm impulse)
maximum spin speed (**)
Operating conditions
Always activated
Door locked
Water level below anti-
flooding level
Maximum time 5 minutes
Door locked
Water level below anti-
flooding level
Maximum time 5 minutes
Door locked
Water level below anti-
flooding level
Maximum time 5 minutes
Door locked
Water level below anti-
flooding level
Maximum time 5 minutes
Door locked
Water level above the
heater
Maximum time 10 minutes
or up to 90°C (*)
Door locked
Water level above the
heater
Door locked
Water level lower than anti-
boiling level for spinning
Door locked
Water level lower than anti-
boiling level
9/91
Function checked
All symbols
are activated
in sequence,
Operation of the
the backlight
user interface
lights up and
then
switches off.
Water ducted through
Displays the
washing
water level in
compartment
tub
Water ducted through
Displays the
pre-wash
water level in
compartment (bleach)
tub
Water ducted through
Displays the
conditioner
water level in
compartment
tub
Water ducted through
Displays the
conditioner/stains
water level in
compartments
tub
Heating
Wash water
Recirculation
temperature
Displays the
drum speed
Check for leaks from
the tub
value divided
Displays the
Drain and spin;
drum speed
control of congruence
in closure of level
value divided
pressure switches
Displays the
Drying
air
temperature
599 70 56-70
LCD
(the real
by ten)
(the real
by ten)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents