Mower Installation - Simplicity 1692450 Operator's Manual

Operation
*2248
Figure 4. Mower Installation & Removal

MOWER INSTALLATION

WARNING
It will be necessary to start the engine to raise or
lower the lift cable. Before starting the engine,
always seat yourself in the operator's position.
Before leaving the operator's position, stop
engine and remove key. Do not engage PTO until
mower is completely installed and operator is
seated.
NOTE: Perform mower installation on a hard, level sur-
face such as a concrete floor.
Refer to figure 4.
1. Park the tractor to the right of the mower and turn the
tractor front wheels fully to the right.
2. Make sure the front idler pulley (L) is installed in top
mounting tab for mower installation. Bottom mounting
tab is used for snowthrower operation.
3. Start the engine. With ground speed control lever in
NEUTRAL, release the clutch/brake pedal. Push the
lift lever forward to lower the cable. Shut off the
engine.
4. Reach under the tractor to grasp the lift cable and
pull it straight down. The lift cable will not lower with-
out weight on it.
*2249
Figure 5. Mower Belt Adjustment
10
A. PTO Clutch Lever
B. PTO Drive Pulley
C. Belt Tensioning Lever
D. Mower Drive Belt
E. Lift Anchor
F. Lift Cable Clevis
G. Deflector
H. Mower Drive Pulley
I. Mower Hitch Arm
J. Tractor Front Hitch
K. Lift Lever
L. Front Idler Pulley
M. Rear Idler Pulley