Table of Contents
Advertisement
ROTARY MOWER
Mfg. No. 599, 28" for use on SERF tractor.
RECOMMENDED ACCESSORIES
Two rear wheel weight Mfg. No. 449 when moving across
slopes between 20% and 40% grade and one front weight
Mfg. No. 466 when moving up slopes between 20% and
40% grade.
Mfg. No. 594 lift lever assembly On Serf adds convenience.
INSTALLATION __
1. If the deflector (vacuum collector adapter if you are
using the vacuum collector) is not already on ypur moy/er,.
install it using the appropriate hardware,. NEVER OPERATE
THE MOWER WITHOUT THE DEFLECTOR OR VACUUM
COLLECTOR ADAPTER IN PLACE.
'' ^ V . .
2. Turn the tractor wheels all the way to the right. .
3. Slide the mower under the tractor from the left side of
the tractor and straighten the wheels.
4. Attach the mower hitch arms to the ears on the tractor
front axle.
U,se two pins and spring clips, placing them
through the front holes in the ears and the. hole at the end
the hitch arms. (See Figure 1).
FIGURE 1
5. (Serf tractor with 594 lift kit) Place the tractor lift lever
in the back position and attach the lift chain to the lift lever
using the pin and spring clip. (See Figure 3).
(Serf tractor) Be sure the belt is placed around the mow¬
er pulleys as shown in Figure 2. Feed the free end of the
belt under the front axle, around the idler pulleys and over
OPERATION ____.
MOWER OPERATION
1. Lower the mower to operating position by grasping the;
lift lever handle, depressing the thumb button to Tree the
latch and moving the lever back. On a Serf without the lift
lever, grasp the mower and unhook the wire hook. NEVER
OPERATE THE MOWER IN THE RAISED POSITION!
2. So that the engine will absorb the additional load, move
the engine speed control lever up so the engine runs at
three-fourths to full speed.
3. Engage the mower by pushing the power take-off lever
forward and down all the way.. (See Figure 4).
15
Advertisement
Table of Contents
Troubleshooting
