Surround Back Speaker Size; Surround Back Speaker Single Or Double; Sub Woofer Selection; Front Speaker Distance - Sony STR-DE1075 Operating Instructions Manual

W Surround back speaker size
(SURR BACK) -
If you connect a large speaker that will
effectively reproduce bass frequencies, select
"LARGE". Normally, select "LARGE".
However, if the front speakers are set to
"SMALL", you cannot set the surround back
speaker to "LARGE".
If the sound is distorted, or you feel a lack of
surround effects when using multi channel
surround sound, select "SMALL" to activate
the bass redirection circuitry and output the
center channel bass frequencies from the front
speakers (if set to "LARGE") or sub woofer.
If you do not connect a surround back speaker,
select "NO".
If you use the surround back speaker in the 2nd
room, select "2ND ROOM'. When the
surround back speaker is set to "2ND ROOM',
the center speaker is also automatically set to
"2ND ROOM' (unless preciously set to "NO").
Tip
Internally, the LARGE and SMALL settings for each
speaker determine whether or not the internal sound
processor will cut the bass signal from that channel.
When the bass is cut from a channel, the bass
redirection circuitry sends the corresponding bass
frequencies to the sub woofer or other "LARGE"
speakers.
However, since bass sounds have a certain amount of
directionality, it best not to cut them, if possible.
Therefore, even when using small speakers, you can
set them to "LARGE" if you want to output the bass
frequencies from that speaker. On the other hand, if
you are using a large speaker, but prefer not to have
bass frequencies output from that speaker, set it to
"SMALL".
If the overall sound level is lower than you prefer, set
all speakers to "LARGE". If there is not enough bass,
you can use the equalizer to boost the bass levels. To
adjust the equalizer, see page 34.
n Surround back speaker single or
double (SURR BACK UR)
l
When the center speaker is set to "NO" and you
use the center speaker as a surround back right
speaker and use the surround back speaker as a
surround back left speaker, select "YES".
l
If you use only a surround back speaker, select
"NO".
n Sub woofer selection (SUB WOOFER)
If you connect a sub woofer, select "YES".
If you do not connect a sub woofer, select
"NO". This
activates the bass redirection
circuitry and outputs the LFE signals from other
speakers.
In order to take full advantage of the Dolby
Digital bass redirection circuitry, we
recommend setting the sub woofer's cut off
frequency as high as possible.
n Front speaker distance (FRONT)
Set the distance from your listening position to
the front speakers (0 on page 17).
n Center speaker distance (CENTER)
Set the distance from your listening position to
the center speaker. Center
speaker distance
should be set from a distance equal to the front
speaker distance (0 on page 17) to a distance
5 feet closer to your listening position (0 on
page 17). When this range is exceeded, the
display blinks. If you make the setting while
the display blinks, you cannot fully enjoy the
surround effect.
continued
19