Installing The Batteries; External Input Mode - Durabrand RSDCC1303 Owner's Manual

CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE
BOX
If your cable service supplies you with a converter
box or if you use a satellite system, you can use the
basic connection shown here.
By using this connection you can also record scram-
bled channels. However, channel selection must be
made with the converter box or satellite box. This
means that channels cannot be changed using the
TV/VCR Remote Control. Unattended timer record-
ing is limited to one channel at a time.
O U T
IN
75-ohm Coaxial
Cable
(Not supplied)
ANT.
TO RECORD A SCRAMBLED/UNSCRAMBLED
CHANNEL
1. Set the TV/VCR channel selector to the output
channel of the Cable Converter Box or Satellite
Box. (Ex. CH3)
2.Select the channel to record from your Cable
Converter Box or Satellite Box.
Satellite Box or
Cable Box (Not supplied)
From Cable System
or Satellite Dish
ANT.

INSTALLING THE BATTERIES

1)Open the battery compartment cover by pressing
the cover on the remote unit in the direction of the
arrow.
2)Insert 2 "AA" penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the cover.

EXTERNAL INPUT MODE

When using an external input signal (another VCR or
camcorder), connect the player's audio/video output
cables to the AUDIO IN/ VIDEO IN jacks of your
TV/VCR. Then press the CHANNEL K or L button
until "AUX" appears on the screen.
- 11 -
AUX
EN
9I03