Cpu/Fin/Dc Fan - Toshiba TECRA M11 Series Maintenance Manual

4.20 CPU/Fin/DC fan

4.20 CPU/Fin/DC fan
Removing the CPU/Fin/DC fan
To remove the CPU/fin/DC fan, follow the steps below and refer to Figure 4-40 to 4-42.
1. Disconnect the fan harness from the connector CN3380 on the system board.
2. Remove the following screws and fin (with the DC fan).
•
M2.0×4B
NOTE: When removing the fin, be sure to remove the screws in the reverse order of the
number marked on the fin.
3. Disconnect the DC-IN harness from the connector CN8800 on the system board.
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
BIND screw
4 Replacement Procedures
×8
[CONFIDENTIAL] 4-73