Toshiba TECRA M11 Series Maintenance Manual page 327

4 Replacement Procedures
Installing the Optical disk drive
To install the Optical disk drive, follow the steps below and refer to Figure 4-17 to 4-19.
NOTE: When installing a new optical disk drive, set the ODD bezel to the optical disk
drive while securing the latches.
1. Set the ODD rear bracket to the optical disk drive and secure them with the
following screws.
•
M2.0×3C
2. Insert the optical disk drive assembly into the slot to connect it to the connector on
the system board.
3. Turn over the computer and secure the optical disk drive assembly with the following
screw.
•
M2.5×5B
4-36 [CONFIDENTIAL]
4.9 Optical disk drive (DVD-ROM/DVD-Super Multi drive)
BIND screw
FLAT HEAD screw
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
Optical disk drive
×2
×1
ODD bezel