Table of Contents
Advertisement
FROM ACCIDEnTAL
OPERATIOn: Turn the tool off
and remove Battery
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVEnT SERIOuS
InjuRY FROM TOOL
FAILuRE: Do not use
damaged equipment. If
abnormal noise or vibration
occurs, have the problem
corrected before further use.
Problem
Tool will not start.
Performance
decreases over time.
Excessive noise or
rattling.
Overheating.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
SKU 67028
TO PREVEnT
SERIOuS InjuRY
Troubleshooting
Possible Causes
1.
No power at outlet during
charging.
2.
Tool's thermal reset breaker
tripped (if equipped).
3.
Internal damage or wear.
(Carbon brushes or switch, for
example.)
1.
Accessory dull or damaged.
2.
Carbon brushes worn or
damaged.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
1.
Forcing tool to work too fast.
2.
Accessory misaligned.
3.
Accessory dull or damaged.
4.
Blocked motor housing vents.
For technical questions, please call 1-800-444-3353.
Cleaning, Maintenance, and
Lubrication
1.
BEFORE EACh uSE,
general condition of the tool. Check
for loose hardware, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
2.
AFTER uSE,
of the tool with clean cloth.
3.
When storing, always store Impact
Wrench in clean, dry and safe loca-
tion out of reach of children.
Likely Solutions
1. Check power at outlet. If outlet is
unpowered, turn off tool and check circuit
breaker. If breaker is tripped, make sure
circuit is right capacity for tool and circuit
has no other loads.
2. Turn off tool and allow to cool. Press
reset button on tool.
3. Have technician service tool.
1.
Keep accessories sharp. Replace as
needed.
2.
Have qualified technician replace
brushes.
Have technician service tool.
1.
Allow tool to work at its own rate.
2.
Check and correct accessory to fence
and/or table alignment.
3.
Keep cutting accessories sharp.
Replace as needed.
4.
Wear ANSI-approved safety goggles and
NIOSH-approved dust mask/respirator
while blowing dust out of motor using
compressed air.
inspect the
wipe external surfaces
Page 9
Advertisement
Table of Contents
