Table of Contents
Advertisement
missing parts. If any problems
are found, do not use tool until
repaired.
Tool Set up
FROM ACCIDEnTAL
OPERATIOn: Turn tool off and
remove Battery before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVEnT SERIOuS
InjuRY: Do not adjust or
tamper with any control or
component in a way not
specifically explained within
manual. Improper adjustment
can result in tool failure or
other serious hazards.
Charging
1.
The Charger (SKU 67031) and
Rechargeable Battery Pack (SKU
67029) are sold separately. Please
refer to the 67031 Charger manual
for important safety warnings and
proper instructions on charging Im-
pact Wrench.
WARnIng!
2.
Do NOT use a different
Charger or Battery Pack to power this
Impact Driver.
general Operating Instructions
1.
With a charged Battery inserted in
tool, select appropriate size 1/4" drive
socket. Use only impact Hex-type
sockets.
2.
Insert the socket into the Quick Re-
lease Locking Collar (13).
SKU 67028
TO PREVEnT
SERIOuS InjuRY
For technical questions, please call 1-800-444-3353.
3.
Insert socket into the nut that is to be
loosened/tightened.
4.
Press down on the Direction Lever
(32). Pressing down on Lever on
Right Housing (35) (with the arrow
facing front of the Impact Driver)
will activate the Forward direc-
tion. Pressing down on Lever on
Left Housing (33) (with arrow facing
away from front) will activate Reverse
direction. nOTE: There is only one
torque setting each for the Forward
and Reverse directions.
5.
Once the direction is selected, hold
the handle firmly and gently squeeze
the Trigger (36). Place other hand on
top of housing to hold securely.
6.
If necessary, press the Work Light
Button (47) to help illuminate work
area.
7.
When the nut is tightened or loos-
ened, release the Trigger.
8.
To prevent accidents, remove battery
from bottom of Impact Wrench and
remove socket from tool. Make sure
to store Impact Driver in a dry, clean
location out of reach of children.
MAInTEnAnCE AnD
SERVICIng
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
REV 09i
Page 8
Advertisement
Table of Contents
