JR SX600 User Manual page 21

CHAPTER 6: FUNCTIONS (SYSTEM MODE)
WING TYPE SELECTION • SYSTEM MODE
6.3
Flaperon, V-tail, and Delta mixing are available
for specialty aircraft that require those
functions. The flaperon feature mixes flaps
with ailerons so the ailerons can be drooped
for takeoffs and landings while still functioning
fully as ailerons. V-tail mixing combines rudder
and elevator for V-tail operations. The Delta
wing function allows the aileron to also act
as the elevator, while retaining independent
use of both functions. The Delta wing function
allows the ailerons to also act as the elevator,
while retaining independent use of both
functions.
Flaperon Setup
When using flaperon mixing, two servos (one
for each aileron) must be used. Connect the
left aileron servo to channel #6 (Flp/Aux 1) and
the right aileron servo to channel #2 (Aile) in
the receiver. Individual functions (e.g., servo
reversing, sub-trims, etc.) are still available
for each of the channels. Use sub-trims for
individual neutral adjustment.
Note: When flaperon is selected, it is
necessary to reduce the travel adjust
values of channel #6 0% in each direction
to prevent servo over-travel (binding).
Please refer to section 7.3 for travel adjust
information.
Press the Scroll button
until
"MIX WING" appears
on the screen.
ACCESSING THE WING TYPE SELECTION FUNCTION
1. Press the Scroll and Increase buttons up
simultaneously and hold.
2. Turn on the transmitter to enter the
System mode.
3. Press the Scroll button until the "MIX WNG"
appears on the screen.
SX600 MANUAL • CHAPTER 6: Functions (System Mode)
MIX
OF
Press the Channel button
to select
Decrease button to turn the flaperon
Wing Type (WNG) or
V-tail (VTL) mixing.
V-tail (VTL) mixing on or off.
CONTINUED
V-Tail
V-Tail mixing requires two servos. Connect the
left tail servo to channel #3 (Elev) and the right
tail servo to channel #4 (Rudd) in the receiver.
Individual functions (e.g., servo reversing, sub-
trims, etc.) are available for each servo. Use
sub-trims for individual neutral adjustments
described in Section 7.2. V-Tail elevator travel
is adjusted by elevator and rudder travel
adjust.
Delta Wing Mixing
Delta or elevon mixing, as it is commonly
known, is the final wing mixing selection in
your SX600. This style of aircraft also employs
two wing servos. However, in essence, there is
not an elevator present. Instead, at an elevator
stick input, the two wing servos function in
conjunction with one another in the same
direction to create an up/down movement of
the aircraft. Also, when an aileron control is
given, the two wing servos move in opposite
directions to function as ailerons as well.
INDICATES WING TYPE FUNCTION
FPR = FLAPERON
VTL = V-TAIL
DLT = DELTA
WING = WING TYPE SELECTION
Press the Increase or
(FPR), Delta (DLT) or
4. Press the Channel button to select either
the wing type (WNG) or V-tail (VTL) mode.
5. Press the Scroll button to access the
modelname function.
6. To exit, press the Scroll and Increase
buttons up simultaneously.
MIX
OF
OF = OFF
ON = ON
21