Speaker Cable Connection; Wall Mount Installation; Using Pre-Installed Brackets - Toa TZ-S60W AS Instruction Manual

[Speaker bracket] [Speaker bracket]
[Speaker bracket] [Speaker bracket]
5.2. Speaker Cable 5.2. Speaker Cable Con Conn n n n ection
5.2. 5.2. Speaker Cable Speaker Cable Con Con
5.3. Wall Mount 5.3.

Wall Mount Installation

Installation
5.3. 5.3. Wall Mount Wall Mount Installation Installation
5.3.1. 5.3.1. 5.3.1. 5.3.1. Using Using pre Using Using pre pre- - - - installed pre installed installed installed brackets
Step 1. Connect the speaker cable to input terminal, where the cable must pass through the hole in the wall Step 1. Step 1. Step 1.
bracket so that the cable do not obstruct the speaker from coinciding with the wall. (refer to below
illustration).
Step 2 2 2 2 . . . . Step Install 4 pieces of
Step Step
distance between the 2 screws is 60mm, height distance is approximately 460mm between the two
screws above and below, and the depth distance of each screw is more than 4mm from the wall
surface. (refer to below illustration).
ACCESSORY ACCESSORY
ACCESSORY ACCESSORY
( ( ( ( Brackets are not yet installed on the speaker) ) ) )
o
30 °
[Joint bracket] [Joint bracket] [Joint bracket] [Joint bracket]
ection
ection ection
[Input terminal polarity]
brackets brackets brackets. . . .
screws, two screws should be paralleled above the other 2 screws. The width
o
30 °
[Wall bracket] [Wall bracket] [Wall bracket] [Wall bracket]
[Striped conductor of cable]
7