Call Hold Reminder Timer & Call Hold Reminder Frequency Parameters - Aastra 9143i Series Release Notes

Call Hold Reminder Timer & Call Hold Reminder Frequency
Parameters
There are two parameters an Administrator can set on the IP Phones along with the
"call hold reminder" and "call hold reminder during active calls" parameters:
• call hold reminder timer
• call hold reminder frequency
These parameters specify the time delay and time frequency of the ring splash that
sounds when you are on an active call and have placed another call on hold. You can
configure these parameters using the configuration files only.
Notes:
• You must enable the "call hold reminder" and/or "call hold reminder during active
calls" parameter(s) for the above parameters to work.
• Setting "call hold reminder frequency" to zero (0) disables this feature.
• Setting the "call hold reminder timer" to zero (0) disables subsequent rings.
Configuring "Call Hold Reminder Timer" Using the Configuration Files
Use the following parameter to configure this feature using the configuration files.
Parameter –
call hold reminder timer
Description
Format
Default Value
Range
Example
RN-001029-05 REV 00 – 04.2010
Configuration Files aastra.cfg, <mac>.cfg
Specifies the time delay, in seconds, that a ring splash is heard on
an active call when another call was placed on hold. For example,
if a call comes into Line 1, and then a call comes into Line 2 and
you answer Line 2, Line 1 is automatically placed on hold. While
on the active Line 2, after 7 seconds, a ring splash audio sounds on
the line reminding you that the call on Line 1 is still on hold. This
timer begins to increment after Line 2 is answered.
Notes:
• This parameter is used with the "call hold reminder frequency"
parameter.
• You must enable this "call hold reminder timer" parameter for it
to work.
• A value of "0" disables the call hold reminder feature.
Integer
7
0 to 4294967295 seconds
call hold reminder timer: 10
New features in release 2.6
31