Precor C944 Service Manual page 37

Replacing the Lift Platform
6. With the treadmill still on its left side, position the lift platform at its mounting position.
7. Replace the two bolts and nuts that secure the lift platform to the treadmill frame.
Note:
The original nuts used to mount the lift platform are Kep nuts, which do not require a separate
washer. If you do not use Kep nuts to mount the lift platform, use washers when you mount the
lift platform to the treadmill frame.
8. Replace the bolt that connects the actuator block to the lift platform.
9. Replace the lower bolt and nut that secure the lift motor to the treadmill frame.
10. Check the operation of the treadmill as described in Section Three of this appendix.
C944 Treadmill
Page 37