13. If the center of the wheel on the zero sense switch is above the widest point of the switch
actuator . . .
THEN . . .
Move the switch bracket down until
the widest part of the actuator is
centered on the wheel on the zero
sense switch; then continue with
the next step.
14. Tighten the socket head bolts and washers that secure the switch bracket to the lift platform
(see Diagram 4.2).
15. Replace the hood.
16. Check the operation of the treadmill as described in Section Three of this appendix.
IMPORTANT
If the electronic console displays the diagnostic message LIFT ERROR PRESS STOP when you
incline and decline the running bed to its maximum limits, repeat this procedure.
If readjusting the position of the switch actuator does not fix the problem, refer to Procedure 2.4
in this appendix.
OTHERWISE . . .
Move the switch bracket up until the
widest part of the actuator is centered
on the wheel on the zero sense switch;
then continue with the next step.
C944 Treadmill
Page 17