ELNA TX Instruction Manual page 48

The material Is fed unevenly Pages The motor runs but the machine does not Pages
- Needle plate not fitted properly .......... 46-47
- Tighten the flywheel coupling knob ...... 12-13
/
- Sewing foot not lowered or not attached
securely
The bobbin winder runs but the machine does not
- Sewing foot not suitable for the kind of work 22-35
- Tighten the flywheel coupling knob . ..... 12-13
- Stitch length not suitable for job
- Stitch length (for superautomatic stitches) The stitch selector cannot be turned
not set at "S" red ..................... 29-31
- Feed dog needs cleaning .............. 46-47
-
Stitch width dial should be set at",....
It is not possible to obtain the stitch desired
The front protection flap cannot be closed
- Stitches in the green zone: stitch length dial - Thread take-up lever should be at its lowest
should be set between
1/
and 4. position ............................. 47
- Stitches in the red zone: stitch length dial
should be set at "S" red, in the notch (click The protection flaps cannot be put beck Into place
stop).
- Put them back according to the red marks. 4-5
The needle breaks The left protection flap cannot be put beck into place
- Foot, needle plate and darning plate not - Not fitted properly, the red dot should be on
fitted properly ................... 8, 34 and 46 the outside ..........................
4-5
- By pulling the material, the needle strikes
the foot or the needle plate The machine will not run
- Needle too fine for the material and the
thread ..............................
40
-
Check power supply
-
Needle not of the system 130/705 H (15 X 1),
- Switch on the safety switch .............
10-11
of poor quality, bent, not inserted properly,
-
Darning foot not fitted corrrectly .........
34-35
not suitable for the kind of work ....... 9 and 40
-
Upper tension too tight ..... .........
41 -
Remains of thread or lint in the rotary hook:
a
Remove needle, bobbin and needle plate
The machine runs too slowly
* Turn the flywheel slightly by hand, several
-
Tighten the flywheel coupling knob ...... 12-13
times, first backwards, then forwards, until
-
Disconnect and reconnect the foot control. 11
the thread tangle has been cuL Clean out
Check that the slide of the speed controller
the remains of thread ..... ...
46-47
is at the top ..........................
11
* Oil the rotary hook and run the machine
n a
- Put
a drop of oil in the rotary hook ......
12-13
without thread for a few seconds ...... 13
The machine Is noisy
The buttonhole is not sewn correctly
-
Rotary hook has not been oiled or is dirty . 12-13 - Wrong foot and stitch length too short .... 32-33
- Needle is blunt
A-I 0.86-
Anglais
- N
0
103 382-1
t
Tavaro $A., Genbve
-
Suiss