Attach Detergent Siphon Hose To Pump; Add Engine Oil - Briggs & Stratton FACTORY RECONDITIONED PRESSURE WASHER Operating And Maintenance Manual

To attach handle supplied with "L" hooks or Wireform:
Note: Your unit may be supplied with "L" hooks or wireform
spraygun holders.
1. Follow steps 1 and 2 in the section To attach handle
with accessory tray or cleaning tank.
2. Insert one "L" hook through hole just above billboard
or cleaning tank on left side of handle (viewing from
front of unit) and attach plastic knob. Tighten knob by
hand (see Figure 4).
OR
Figure 4 — Attach "L" Hooks to Handle
3A. Insert other "L" hook through hole just below billboard
on right side of handle (viewing from front of unit) and
attach plastic knob. Tighten knob by hand (see
Figure 4).
3B. Insert other "L" hook through hole just above billboard
or cleaning tank on right side of handle (viewing from
front of unit). Hold hook in place and attach plastic
knob from inside of unit (see Figure 4). Tighten by
hand.
4. Insert spray gun holder wireform (A) through hole on
left side of handle (viewing from front of unit). Hold
wireform in place and attach a plastic knob (B) from
inside of unit. Tighten by hand (see Figure 5).
A
Figure 5 — Attach Wireform to Handle
To attach a slip-over handle:
A slip-over handle has a built-in nozzle storage tray as part
of the handle.
1. Follow steps 1 and 2 in the section To attach handle
with accessory tray or cleaning tank.
2. Insert multi–colored spray tips in spaces provided in
handle.

Attach Detergent Siphon Hose to Pump

If equipped with a cleaning tank, attach detergent siphon
hose to barbed hose fitting on pump (see Figure 6).
Figure 6— Attach Detergent Siphon Hose to Pump

Add Engine Oil

1. Place generator on a flat, level surface.
2. Clean area around oil fill and remove oil fill cap.
Refer to Oil Recommendations in Maintenance for oil
specifications.
Any attempt to crank or start the engine before it has been
properly filled with the recommended oil will result in
equipment failure.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
3. Using oil funnel (optional), slowly pour oil into oil fill
opening. On engines without a dipstick, fill to the top
of the oil fill opening, checking oil frequently. DO NOT
overfill. Refer to Adding Oil in Maintenance for detailed
B
instructions.
4. Replace oil fill cap and fully tighten.
NOTICE
7