Optional Equipment; Tools And Supplies; Disconnecting The Battery - Jensen VM9022HDN Installation And Operation Manual

Optional Equipment

•
Rear Camera
The VM9022HDN is "camera ready." Before accessing
any camera features, you must purchase and install a
rear video camera. Once the rear camera is connected
and operating properly, the CAMERA source mode will
become active. While the camera is not installed, the
CAMERA option appears gray, indicating the function is
not available.
•
Satellite Radio Tuner
See "Satellite Radio Operation" on page 22.
•
jLinkCable and iPod
See "MP3/WMA Operation" on page 28.
•
Bluetooth Phone
See "Bluetooth Operation" on page 32.
•
3.5mm to 3.5mm Audio Cable
Sold separately at various retailers.
What's in the Box
1. Left and Right Double DIN Mounting Brackets
2. Double DIN Half Sleeve Install Bracket
3. Remote Control with Battery
4. Rear Support Mounting Strap
5. jLink iPod Cable
6. HD Radio Module
7. HD Radio Module Connecting DIN cable
8. HD Radio Module Mounting Hardware
9. Two Custom Cosmetic Trim Rings
10. Parking Brake Wire
11. MediaLink
12. Screen Cleaning Cloth
13. M5x6 and M3x4 Screws to Mount Radio to Brackets
14. Speaker Output Harness
15. Power Input Harness
16. Center Channel Wire Harness
17. GPS Antenna
18. Back-Up Map Data DVD
19. 2GB SD Card
20. Navigation Instructions

Tools and Supplies

You will need these tools and supplies to install your
VM9022HDN:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket
wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and
remove the negative (-) battery cable prior to installation.
NOTE: If the VM9022HDN is to be installed in a car
equipped with an on-board drive, do not disconnect the
battery cable. If the cable is disconnected, the computer
memory may be lost. Under these conditions, use extra
caution during installation to avoid causing a short
circuit.
WARNING! Only connect the unit to a 12-volt power
supply with proper grounding.
WARNING! Never install this unit where operation and
viewing could interfere with safe driving conditions.
WARNING! To reduce the risk of a traffic accident (except
when using for rear view video camera), never use the
video display function while driving the vehicle. This is a
violation of federal law.
WARNING! Never disassemble or adjust the unit.
WARNING! To prevent injury from shock or fire, never
expose this unit to moisture or water.
WARNING! Never use irregular discs.
2
VM9022HDN
WARNING! To prevent damage to the mechanism inside
this unit, avoid impact to the TFT monitor.
WARNING! Using an improper fuse may cause damage
to the unit and result in a fire.