Introduction - Jensen VM9022HDN Installation And Operation Manual

VM9022HDN Navigation Module

INTRODUCTION

The VM9022HDN navigation module leads you straight to your destination. You can navigate
and plan your route with an easy-to-use and intuitive interface, plan your trip to suit your
personal preferences and interests, and find and save (bookmark) interesting destinations
before you begin your trip.
Key Features
TM
• S.M.A.R.T. - (Smart Mapping Avoids Routine Traffic) enables you to navigate around
heavy traffic areas with ease. (S.M.A.R.T. Route Guidance)
• Powered by gate5 / Nokia Smart2Go
• Teleatlas Map Data
• > 4 million POI (Point Of Interest)
• Speed Sensitive Zoom
• Enhanced Female TTS Voice Guidance Engine
• Standard Male / Female Voice Guidance Engine
• Turn by Turn Voice Guidance
• Back-Up Data DVD
Smart2Go Navigation / Tele Atlas Map Data
The VM9022HDN Jensen 2GB SD card is pre-loaded with the Smart2Go navigation engine
and Tele Atlas map data. The map data covers the continental US, Canada, Alaska, Hawaii
and Puerto Rico. Insert the Jensen 2GB SD card into the NAV/MAP SD slot located behind the
front panel and gently press the card in against the spring latch until it stops, then release. The
card will "lock" firmly into place inside the SD card slot.
EJECT
About GPS and GNSS
The navigation module is a vehicle GPS (Global Positioning Satellite)-based navigation system
which utilizes digital map data to guide you from your selected location A to location B, using
location information obtained from a Global Navigation Satellite System (GNSS).
A GNSS consists of a set of satellites that transmit high-frequency radio signals containing
time, direction, and distance data that can be picked up by a receiver, allowing users to
pinpoint their precise locations anywhere around the globe. Navigation Satellite Receivers
(GPS devices) use this transmitted information to calculate an exact location on the earth.
Every point on Earth can be identified by latitude and longitude. The receiver uses the
information sent by at least three satellites and determines the coordinates of the receiving
device.
By comparing the time the signals were transmitted from the satellites and the time they were
recorded, the receiver calculates how far away each satellite is. The distance of the receiver
from three or more satellites reflects its position on the surface of the planet. Using these
distance measurements, the receiver might also be able to calculate speed, bearing, trip time,
distance to destination, altitude, etc. The GPS position may be displayed as a point on a digital
map (at least three satellites' signals must be received) and as the GPS device moves the
corresponding trace is displayed as well.
Please keep in mind that although the radio signals of navigation satellites will pass through
clouds, glass, plastic, and other lightweight materials, satellite-navigation receivers will not
work underground or in some enclosed spaces.
UP
UP
NAV/MAP
CARD
READER
39