Peavey MediaMatrix Nion Hardware Manual page 45

1. Configure the PC with an IP address in the same subnet as is noted on the while sticker on
the back of the NION. For example, if the sticker shows 10.7.5.75, then your computer's IP
address will be 10.7.5.X where x is any value below 75, such as 10.7.5.66.
2. Set the subnet mask to 255.255.255.0.
3. Connect the PC to the NION using an Ethernet switch or crossover cable.
4. Open a web browser and enter the NION default IP address (see white sticker) into the
web address bar.
5. Click the Network tab.
If a different static IP address is required then:
a) Make sure that static is selected in the IP Configuration Method list.
b) Fill in IP address and netmask value appropriate to your network. The Gateway and
DNS entries can also be entered if required.
Note: To change settings on the web interface a user name and password is needed. The
default username is superuser; it has no password.
If DHCP is required for set-up purposes, select DHCP in the IP Configuration Method
list.
June 11, 2012 Version 1.6.4b.1
NION Hardware Manual
41