What Distinguishes The Two Units; Choosing A Place For Each Unit - Bose Link AL8 Owner's Manual

Homewide wireless audio link

Hide thumbs Also See for Link AL8:

Table of Contents

INTRODUCTION

What distinguishes the two units

The connection panel on each unit identifies it by name: TRANSMITIER or RECEIVER. Two

Bose® link jacks and a Channel button further distinguish the transmitter.

For compatibility, the two units have a matching Setup Code, set at the factory with both

switches in the "up" position (Figure 2). A Status LED lights when each unit is plugged in and

the two units are communicating.

Setup

Code

Receiver

Setup

Code

Transmitter

Status LED - - - - - - - '

;

Note: For information on the meaning of the different Status LEO lights, refer to

"Check the indicators and settings" on page 8.

Figure 2

Connection panels on the

two units

Choosing

place for each unit

Place the transmitter in the same room with the LIFESTYLE® system media center. Place the

receiver in the same room with your Bose link expansion product.

;

Note: Use of the audio link with products that are not Bose link compatible requires an adapter

cable. For further information, refer to "Instructions for non-Bose or older Bose products" on

page 7.

Considerations for positioning:

• Place each unit upright with all feet flat on a level surface, such as a floor, table, or shelf.

• Do not tip either unit on its side.

• Place each unit within 7 feet (2 meters) of the product to which it is connected (using the

supplied Bose link A cable).

• Keep the two units within 80 feet (24 meters) of each other.

• SBe aware that the strongest signal direction is above and around, not below,

the transmitter.

Table of Contents