Murray Parklander2690997 Operator's Manual page 33

Problem
The grass does not discharge
correctly.
The mower housing does not
cut level.
The mower blades will not
rotate.
The unit will not move.
Belt noise can be heard.
The rear wheels spin over
uneven terrain.
Troubleshooting Chart Continued
Correction
1. Stop the engine. Clean the mower housing.
2. Raise the height of cut.
3. Replace or sharpen the blade(s).
4 Use a slower ground speed.
5. Move the throttle control to the FAST position.
6. Contact your dealer.
1. Check the air pressure in the tires.
2. Adjust the level of the mower housing.
3. Check the front axle. If the front axle does not freely pivot, loosen the axle bolt(s).
1. Check the mower drive belt. Make sure the belt is installed correctly.
2. Replace the mower drive belt.
1. Release the automatic drive disconnect (Hydro-Drive Models).
2. Contact your dealer.
1. Temporary belt noise does not change the operation of the unit. If belt noise is
continuous, check the routing of the belt. Make sure the belt is inside all belt guides.
2. Contact your dealer.
1. Check the front axle. If the front axle does not freely pivot, loosen the axle bolt(s).
Troubleshooting
33