Magnavox MDV630R Owner's Manual page 70

5
Confirm with OK .
a The following message appears on the screen: 'Please enter
channel number'
b The channel number of the TV channel has not yet been assigned
Guide. Using C , D or the number buttons 0..9 on the remote
control, select the corresponding Guide channel number (name) of
the TV channel and confirm with OK .
a The following message appears on the screen: 'PlusCode
number wrong'
b The entered PlusCode number is incorrect. Correct your entry or
cancel using the SYSTEM-MENU button.
b Check the time/date (see chapter 'Initial installation', section 'Setting
the time and date').
a The following message appears on the screen: 'Date does not
match Mon-Fri'
b A daily recording was entered for the wrong day. Daily programming
can only be used for recordings to be made from Monday to Friday.
6
The data appears after confirmation. You can go back to change
the data. Select the field with C or D . Change the information
with A , B or the number buttons 0..9 .
Changing recording mode in the 'Rec Mode' input field
Select the 'Rec Mode' input field using C . Using B , A select the
recording mode 'HQ, SP+, EP, EP+'.
7
If all information is correct, press the
programming information is stored in a TIMER block.
8
To end, press TIMER .
9
Insert a recordable disc in the Recorder.
10
Switch off the Recorder with STANDBY m .
The programmed recording will only function properly when the
DVD recorder
STANDBY m button.
If any of the TIMER blocks are in use and the recordings are set ot occur, 's' will light up on
the display.
68
OK button. The
has been switched off
Problem
Tip
using the
Programming a recording (TIMER)
Timer
VCR Plus+ system
Date Ch. Start End
01/22 001 08:30AM 10:00PM
Rec
Mode
HQ
To store
Press OK