Assembling Cabinet Top To Cabinet; Assemble Bed To Stand - RIDGID JP0600 Owner's Manual

Assembly (continued)

Assembling Cabinet Top to Cabinet

1. Locate the following:
13 Machine Screws with Washer Heads
2. Place cabinet top upside down on the floor.
3. Position the assembled cabinet upside down on the
cabient top.
4. Fasten in place with 9 machine screws.
5. Fasten chute to cabinet side with 4 machine screws.
6. Turn assembled unit right side up on leveling feet.

Assemble Bed to Stand

1. From among the loose parts, find the following:
3 Jointer Mounting Stud 3/8-16 x 3/4
3 Lockwasher 3/8
1 Handwheel
1 Screw Pan Head 1/4-20 x 1/2
1 Washer 1/4
1 V-Belt
WARNING: This tool is heavy. To reduce the risk of
back injury, get help whenever you have to lift the
tool.
2. Set the bed on top of the stand. Carefully line up the 3
threaded holes in the bed with the 3 slots in the stand.
Attach the 3 studs and lockwashers and tighten.
3. Slip the V-belt over the bed pulley. Lift the motor up
and slip the V-belt around the motor pulley.
Note: Allow the weight of the motor to tension the belt.
No additional tension is required. Visually line up the
motor pulley with the bed pulley and tighten the motor
mounting nuts.
4. Slip the handwheel onto the infeed table elevation
shaft and install the washer and screw.
Machine Screw w/Washer Head
Machine
Screws
16