Furuno GP-7000F Installation Manual page 22

5. Using the vertical adjustment space on the bracket slots, slide the sensor up or down to
provide a projection of 3 mm (1/8"). Tighten the screws.
Attaching the sensor to the bracket
1. If the retaining cover near the top of the bracket is closed, open it by depressing the
latch and rotating the cover downward.
Step 1
Latch
Pivot
arm (2)
Retaining
cover
2. Insert the sensor's pivot arms into the slots near the top of the bracket.
3. Maintain pressure until the pivot arms click into place.
4. Rotate the sensor downward until the bottom snaps into the bracket.
5. Close the retaining cover to prevent the accidental release of the sensor when the boat
is underway.
Cable routing
Route the sensor cable over the transom, through a drain hole, or through a new hole
drilled in the transom above the waterline.
Never cut the cable or remote the connector; this will void the warranty. Always wear safety
goggles and a dust mask.
1. If a hole must be drilled, choose a location well above the waterline. Check for
obstructions such as trim tabs, pumps, or wiring inside the hull. Mark the location with a
pencil. Drill a hole through the transom using a 19 mm or 3/4" bit (to accommodate the
connector).
Hull projection 3 mm (1/8")
Vertical adjustment and cable routing
Step 2
Slot (2)
Attaching the sensor to the bracket
16
Cable cover
Cable
clamp
50 mm (2")
Step 3
Step 4