Electrolux ENV06 Service Manual page 42

Alarm
E69 Washing heating element interrupted (thermofuse open)
Faulty NTC sensor; Wiring faulty;
E71
PCB faulty.
E72 Wiring faulty; Drying NTC sensor (condenser) faulty; PCB faulty.
Wiring faulty; Drying NTC sensor (duct) faulty; PCB faulty.
E73
NTC sensor improperly positioned; Faulty NTC sensor; Wiring faulty; PCB faulty.
E74
E82 PCB faulty (Wrong configuration data). Selector, wiring
E83 PCB faulty (Wrong configuration data). Selector, wiring
Wiring faulty; Faulty control/display board
E91
PCB faulty.
Wrong control/display board;
E92
Wrong PCB (do not correspond to the model).
Incorrect configuration data; PCB faulty.
E93
E94 Incorrect configuration data; PCB faulty.
E95 PCB faulty.
E97 Faulty PCB (Wrong configuration data).
E98 Incompatibility between main board and Inverter.
E9b / E9H Display board.
E9C Display board.
E9d Display board.
E9F PCB.
EH1 Power supply problems (incorrect / disturbance); PCB faulty.
EH2 Power supply problems (incorrect / disturbance); PCB faulty.
EH3 Power supply problems (incorrect / disturbance); PCB faulty.
EHE Wiring faulty; PCB faulty.
EHF PCB faulty.
EC1 Solenoid valve faulty/blocked; PCB faulty.
EC3 Wiring faulty; Weight sensor faulty; PCB faulty.
Ed1 Wiring faulty between PCB and WD board; WD board faulty; PCB faulty.
Ed2 Wiring faulty between PCB and WD thermostats; WD board faulty; PCB faulty.
Ed3 Wiring faulty between PCB and WD thermostats; WD board faulty; PCB faulty.
Ed4 Wiring faulty: WD board faulty; PCB faulty.
SOI/DT 2007-10 dmm
Possible fault
42/48
Action/machine status
----------------
Heating is skipped.
Drying heating is skipped
Drying heating is skipped
Heating is skipped.
----------------
Cycle cancelled.
----------------
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Cycle interrupted.
Wait for frequency nominal
conditions.
Wait for voltage nominal conditions.
Wait for voltage nominal conditions.
Safety drain cycle – Cycle stopped
with door open.
Safety drain cycle – Cycle stopped
with door open.
Cycle interrupted with door closed.
Drain pump functions always (5 min.,
then it stops for 5 min. etc.)
----------------
Cycle interrupted.
Cycle interrupted with door open.
Cycle interrupted with door open.
Cycle interrupted with door open.
Reset
START/RESET
START/RESET
START/RESET
START/RESET
START/RESET
RESET
START/RESET
RESET
OFF/ON START
OFF/ON
OFF/ON
RESET
RESET
OFF/ON
ON/OFF RESET
ON/OFF RESET
ON/OFF RESET
OFF/ON
OFF/ON
OFF/ON
OFF/ON
RESET
RESET
RESET
START/RESET
OFF/ON
RESET
RESET
RESET
599 70 27-90