Processor Reset - Harman Kardon AVR347 Service Manual

AVR347
Erasing Macros
It isn't possible to "edit" a command within a macro. However, you may erase the macro as
follows:
•
Simultaneously press and hold the Mute Button and the Macro Button containing the
macro until the LED flashes.
•
Press the Surround Button to erase the macro.
Resetting the Remote
To reset the remote to its factory defaults, simultaneously press and hold any Input Selector and
the "0" Numeric key. When the Program LED flashes in amber, enter the code "333". When the
green LED goes out, the remote will have been fully reset.

Processor Reset

There may be instances when you wish to fully reset the AVR 347 to its factory defaults, or the
unit may behave erratically after a power surge. To correct erratic behavior, first try turning the
Master Power Switch off and unplugging the AC power cord for at least three minutes. Plug the
cord back in and turn the receiver back on. If this doesn't help, try a system reset.
NOTES:
•
A system reset erases all user configurations, including speaker and level settings and
tuner presets. After a reset, you will need to reenter all of these settings.
•
The RS-232 Reset Button on the rear panel of the AVR 347 does not perform a system
reset. DO NOT press the RS-232 Reset Button.
To reset the AVR 347, place the receiver in Standby mode (press the front-panel Standby/On
Switch so that the Power Indicator turns amber). Then press and hold the front-panel Tone
Mode Button for at least five seconds until the RESET message appears in the display.
Memory
If the AVR 347 is unplugged or experiences a power outage, it will retain user settings for up to
four weeks.
42
harman/kardon