Connections
●
External equipment and cables shown are not supplied with this TV.
●
Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
●
Check the type of terminals and cable plugs are correct when connecting.
●
When using an HDMI cable, use the fully wired one.
●
Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.
●
Also read the manual of the equipment being connected.
Terminals
Basic connections
Mains lead and aerial
Special notices for receiving digital terrestrial services
●
If you receive analogue and digital TV signals through two separate aerials, use an RF mixer to mix them.
●
If you receive analogue TV signals through a cable TV network, an aerial is required to receive digital TV signals.
In this case, using an RF mixer is not recommended because the TV signals interfere with each other.
●
An RF selector is available to switch analogue and digital TV signal.
6
1
6
5
Analogue and Digital
TV signal
Analogue or Digital
TV signal
1
USB 1 - 2 port
2
HDMI1 - 3
3
Aerial terminal
(see below)
2
4
AV1 (COMPONENT / VIDEO)
(p. 8)
5
DIGITAL AUDIO OUT
6
ETHERNET
3
4
Aerial
Analogue TV
RF mixer
Cable
Analogue TV
RF selector
(p. 8)
Aerial
Digital TV
Aerial
Digital TV
A
5
●
●
●
●
●
●
●
●
■
T
■
T