First Time Auto Tuning - Panasonic Viera E6G series Operating Instructions Manual

First time Auto Tuning

Automatically sets up the TV and searches for available TV channels when the TV is turned on for the first time.
● These steps are not necessary if the setup has been completed by your local dealer.
●
Please complete connections (p. 6 - 9) and settings (if necessary) of the connected equipment before starting Auto
Tuning. For details of settings for the connected equipment, read the manual of the equipment.
Plug the TV into mains socket and turn power on
1
●
Takes a few seconds to be displayed.
Select the following items
2
Set up each item by following the on-screen instructions.
Select your language
Select [Home]
Select [Home] viewing environment to use in your home environment.
●
[Shop] is for shop display.
● To change viewing environment later on, you will need to initialise all settings by accessing Shipping Condition.
Set up the network connection
Select your country
Tick the TV signal mode to tune, and then select [Start Auto Tuning]
: tune (search for the available channels)
: skip tuning
●
If you use an RF selector, switch it to the digital TV signal before starting the Auto Tuning. As soon as the
digital TV scan is finished, switch it to the analogue TV signal to tune analogue channels. Even if some
channels are not tuned correctly, you can try to tune them by [Auto Tuning] in [Setup] menu.
■
When you select the analogue TV signal, select your area.
●
When selecting [CATV/Other], press the OK button, and then select the Channel Plan from Indian CATV, South
Africa, American System, American CATV or Japan CATV.
Select the type of [Home Screen]
3
The demonstration to explain how to use [my Home Screen] is displayed. Confirm the demonstration by
following the on-screen instructions, and then select the desired [Home Screen].
Example: [Home Screen Selection]
● [my Home Screen] is the start-up screen when the TV is turned on or the HOME button is pressed.
Auto Tuning is now complete and your TV is ready for viewing.
If tuning has failed, check the connection of the network, RF cable, and then follow the on-screen instructions.
Note
● The TV will automatically go into Standby mode when no operation is performed for 4 hours if [Auto Standby] in the
Timer Menu is set to [On].
●
The TV will automatically go into Standby mode when no signal is received and no operation is performed for
10 minutes if [No signal Power off] in the Timer Menu is set to [On].
●
To retune all channels
●
To add the available TV signal mode later
●
To initialise all settings
12
[Auto Tuning] in [Tuning Menu] (Setup Menu)
[Add TV Signal] in [Tuning Menu] (Setup Menu)
[Shipping Condition] in [System Menu] (Setup Menu)
Example: [TV Home Screen]