Advertisement
Option programming
The OneRemote controller inside the Beo4 can be programmed with different options, to
make it fit in different setups. One or more options might need to be set to optimize your
application.
An option programming is carried out by pressing a series of buttons in a sequence that
does not occur during daily use. The programming must be ended within 5 seconds.
An ongoing programming sequence can be cancelled by pressing
All option programming is initiated by pressing
option.
Disable OneRemote Controller Option
The OneRemote controller in the modified Beo4 remote control can be enabled or dis-
abled using this option. When disabled the Beo4 remote control operates as an original
Beo4.
O
t
q
O
t
q
Zap Mode Option
The Beo4 buttons
and
buttons are used to manoeuvre up and down in an on-screen menu. This
D
F
is the default factory setting, as described in the chapter 'Operating with OneRemote'.
The zap mode option makes it possible to exchange the functions of the up & down but-
tons with the blue & yellow buttons.
O
t
q
O
t
q
20
21
and
W
R
90
91
t
Disables the OneRemote controller.
Enables the OneRemote controller.
are being used for programme stepping, and the
Up & down is programme zap.
Blue & Yellow is programme zap.
6
e
followed by the actual
O
q
.
Factory setting.
Factory setting.
Advertisement
