White Bal; Dis - Samsung SmartDome SCC-C6403P Owner's Instructions Manual

WHITE BAL

Lights are generally denoted as color temperatures and expressed in
Kelvin (K) units.
The general light color temperatures are shown below.
10000K Blue sky
9000K
8000K
Cloudy
7000K
6000K
Sunny
5000K
4000K
3000K
Halogen lamp
2000K
Candlelight
1000K
3-14
Rainy
Partly Cloudy
Fluorescent lamp
Tungsten lamp
You can select one of four modes for white balance adjustment as follows:
- ATW1/ATW2(Auto-Tracing White Balance Mode): In these modes, the
color temperature is monitored continuously and thereby white balance is
set automatically. The following are the approximate supported color
temperature ranges in these modes.
ATW1 : 2500K ~ 9300K( 1)
ATW2 : 2000K ~ 10000K(Mode recommended for sodium lighting)( 2)
1. If the color temperature is out of this range in ATW1 mode, proper
white balance may not be obtained. In that case, select ATW2 mode.
2. In ATW2 mode, if one color is dominated in the shooted area, the
color can be displayed differently.
Therefore, select the mode which is appropriate for the environment.
- AWC(Auto-Tracing White Balance Control): In this mode, accurate white
balance is obtained by pressing [ENTER] while having a white paper in
front of the camera. White Balance data will be maintained after set it
once. AWC mode is best in locations where the color temperature of light
source is constant.
- MANU : If WHITE BAL menu is set to MANU mode, the user can set the
white Balance considering the current illumination. Select MANU item
and press [ENTER], the sub screen where you can select Manual White
Balance will be shown. Use the left/right keys to select 3200K, 5600K or
OFF(USER) mode in the PRESET menu.
- 3200K : Set color temperature to 3200K
- 5600K : Set color temperature to 5600K
- USER : Choose out a proper value from the RED and BLUE graph for
color and temperature setup.
(VIDEO SET)
IRIS ALC...
SHUTTER OFF
AGC LOW
Press
WHITE BAL MANU...

DIS

ON [Enter]
FOCUS MODE ONEAF
SPECIAL ...
EXIT QUIT
DIS
The DIS(Digital Image Stabilization) function compensates the camera
screen shaking incurred from vibration.
It is recommended to deactivate the DIS function in the no vibration
environment.
From VIDEO SET, if you set SHUTTER to between AUTO X2... and AUTO
X128... DIS will be displayed as "---" (it can operate only in Off mode).
You can't adjust the settings manually.
E
(AWB/MANU)
PRESET 3200K
RET
3-15