Speaker Wiring - Jensen POWER 1050 Installation And Operation Manual

POWER Amplifiers

Speaker Wiring

The Speaker Wiring diagrams illustrate options for connecting one or two
speakers. Observe the proper speaker polarity.
NOTE: Power amplifiers can drive speakers with a nominal impedance
range of 2~ 4-ohms. For maximum power, configure your speakers for a
nominal 2-ohm load.
NOTE: Do not overlook the use of the proper gauge speaker wire. The
Power series of amplifiers require a minimum of 12-gauge wire.
Power 900/1050
Two Subwoofer
SPEAKER OUTPUT
– – + +
4 ohm 4 ohm
One Subwoofer
SPEAKER OUTPUT
– – + +
4 ohm nominal
Power 400/880
Two Speakers
4 ohm nominal
SPEAKER OUTPUT
+ LEFT - + RIGHT -
BRIDGED
MODE X-OVER
MONO STEREO FULL HPF
LPF
Tri-Mode
L
Inductor
X-OVER C
HPF
FULL
LPF
C
Capacitor
6
One Subwoofer
4 ohm nominal
SPEAKER OUTPUT
+ LEFT - + RIGHT -
BRIDGED
MODE X-OVER
HPF
MONO STEREO FULL
LPF
SPEAKER OUTPUT
+ LEFT - + RIGHT -
BRIDGED
L
4 ohm nominal