Motor Replacement - Graco 261825 Operation Manual

Motor Replacement

See Wiring Diagram, page 27.
CAUTION
Do not drop gear cluster (27) and (26) when removing
drive housing (29). Gear cluster may stay engaged in
motor frontend bell or drive housing.
Removal
1. Relieve pressure, page 6. Disconnect power cord
from outlet.
2. Remove kick stand (66) (210
3. Remove two screws (5) and toolbox (3) (190
210 Series A).
ES
4. Remove pump, Displacement Pump
Replacement, page 12.
5. Remove drive housing, Drive Housing
Replacement, page 14.
6. Remove control board, Control Board
Replacement, page 18.
1
3
5
66
26
Series A).
ES
,
ES
57
20 G 4
7. Remove two screws (4) and filter manifold (43).
8. Remove green ground screw (20) and ground wire
(G) from motor endbell.
9. Remove cover (14). Remove four screws (4) and motor
(57) from frame (1).
Installation
1. Install cover (14) on motor (57). Install motor on
frame (1) with four screws (4).
2. Connect green ground wire (G) to frame with green
ground screw (20). Be sure green ground wire ter-
minal faces up or wires could get caught in shroud.
(See illustration, page 25.)
3. Install manifold (43) with two screws (4).
4. Install control board, Control Board Replacement,
page 18.
5. Install drive housing. Drive Housing Replacement,
page 14.
6. Install pump. Displacement Pump Replacement,
page 12.
7. Install toolbox (3) with two screws (5) (190
Series A).
8. Install kick stand (66) (210
1
2
11
18
11
ti9158a
Motor Replacement
ES
Series A).
ES
14
43
4
1 Liberally apply grease
, 210
ES
311990H