Specifications - Makita TD090D Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745-2-2:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
Overall length
Net weight
Rated voltage
equipment and
environmentally compatible
) : 92 dB(A)
pA
) : 103 dB(A)
WA
value (tri-axial vector
2
) : 10 m/s
h
2
END004-3
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
its
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENE033-1
EC Declaration of Conformity
ENG102-2
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine: Cordless Impact Driver
Model No./ Type: TD090D
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
ENG205-1
And are manufactured in accordance with the following
standards or standardised documents:
sum)
EN60745
The technical documentation is kept by our authorised
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
2
TD090D
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 2,400
0 - 3,000
155 mm
0.92 kg
D.C.10.8 V
Corporation as the
ENG901-1
ENH101-12
responsible