Verify Anti-Tip Is Installed And Engaged - Jenn-Air W10253462A User Manual

10. Depending on your installation, connect the flexible vent from
the blower motor inlet to the range using a vent clamp.
Wall Venting
C
A. Range
B. Wall venting outlet
C. Vent clamp
Floor Venting
C
A. Range
B. Floor venting outlet
C. Vent clamp
Top View
B
A
Top View
B
A
Side Venting (left side venting shown)
Connect flexible vent duct to range and connect vent system
to blower motor outlet.
E
D
A. Flexible vent duct to range
B. Vent clamp
C. Range

Verify Anti-Tip Is Installed and Engaged

1. Verify the anti-tip bracket is installed and engaged.
Use a flashlight to look underneath the bottom of the
range.
Visually check that the rear foot is inserted into the slot of
the anti-tip bracket.
2. Replace access panel.
el .
Top View
A
BLOWER
C
B
D. Vent system
E. Side venting outlet
21