Setting Hi/Lo Switch (Motor Speed); Adjusting Pressure - Graco 3A1698F Operation Manual

Setting Hi/Lo Switch
(Motor Speed)
Low Speed
ti16731a
1. To extend battery life, try spraying with low motor
speed to get an acceptable spray pattern.
2. Shift to high speed if needed to achieve an accept-
able spray pattern.
10
High Speed
Speed Control
Switch

Adjusting Pressure

ti16705a
Minimum Pressure Setting
1. To reduce overspray, always spray at lowest pres-
sure that results in an acceptable spray pattern.
2. Spray test pattern and adjust pressure to get
desired coverage.
3. With some materials, if pressure is set too low, no
material may spray out. Turn pressure control up.
Common Procedures
ti16704a
Maximum Pressure Setting
3A1698F