Fisher-Price Power Wheels B7659 Owner's And Assembly Manual page 9

2
Battery
Clamp Unit
• Insert two #10 x 1" screws through the holes in the
battery clamp unit and into the pegs in the dash.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
3
Battery Clamp
2
• Position the dash on the vehicle body.
• Make sure the motor harness connector wire is through
the groove in the dash.
• Insert a #10 x 1 / " screw through each of the two corner
2
dash tabs nearest to the passenger compartment
• Insert a #10 x 1" screw through the two dash tabs
nearest to the battery compartment
• Insert a #10 x 1" screw into the hole in the center of the
dash, near the battery retainer clip
• Tighten the screws with a Phillips screwdriver. Do not
over-tighten.
Assembly
Dash
Motor
Harness
Connector
Wire
Battery
Compartment
1
.
.
.
9
4
13
21
16
Labels - Dash
• Before applying the labels, wipe the surface of the
vehicle with a clean, dry cloth to remove any dust or oils.
• Place the labels exactly as shown in the illustrations.
• For best results, avoid repositioning a label once it has
been applied to the vehicle.
15
14
12
17
HI LO KC
23